User's Manual

Note
If you select the enrollment staon, you should click Login t
o set related parameters of the
device including IP address, port No., user name, and password. Also, you can check Face An-
Spoong and select the liveness level as Low, Medium, or High.
Face An-Spoong
If you check this funcon, then the device can detect whether the face to be collected is an
authenc one.
6.
Collect f
ace.
1) Face to the camera of the selected access control device and make sure your face is in the
middle of the collecng window.
2) Click
to capture a photo.
3)
Click OK to save the captured photo.
7.
Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons .
9.4.7 Congure Access Control Informaon
When adding a person, you can set her/his access control informaon, such as binding an access
control group with the person, conguring PIN code, seng the person as a visitor, a blocklist
person, or a super user, etc.
Steps
1.
Enter Person module.
2.
Select an organizaon in the organizaon list to add the person and click Add.
3.
In the Access Con
trol area, click
to select access group(s) for the person.
Note
For details, refer to Set Access Group to Assign Access Authorizaon to Persons .
DS-K5671B Series Face Recognion Terminal User Manual
143