User's Manual

Device Account
Enter the account name registered on ISUP protocol.
ISUP Key
For ISUP 5.0 devices, enter the ISUP key if you have set it when conguring network center
parameter for the device.
Note
This funcon should be supported by the device.
5.
Oponal: Check S
ynchronize Time to synchronize the device me with the PC running the client
aer adding the device to the client.
6.
Oponal: Check Import to Group to create a group by the device name, and import all the
channels of the device to the group.
7.
Finish adding the device.
-
Click Add to add the device and go back to the device list.
-
Click Add and New to save the sengs and connue to add other device.
8.
Oponal: Perform the following operaon(s).
Device Status Click
on Operaon column to view device status.
Edit Device
Informaon
Click on Operaon column to edit the device informaon, such as
de
vice name, device account, and ISUP key.
Check Online User Click
on Operaon column to check the online users who access the
de
vice, such as user name, user type, user's IP address, and login me.
Refresh Click
on Operaon column to get the latest device informaon.
Delete Device Select one or mulple devices and click Dele
te to delete the selected
device(s) from the client.
Import Devices in a Batch
You can add mulple devices to the client in a batch by entering the device parameters in a pre-
de
ned CSV le.
Steps
1.
Enter the Device Management module.
2.
Click Device tab on the top of the right panel.
3.
Click Add to open the Add window, and then select Batch Import as the adding mode.
4.
Click Export Template and then save the pre-dened template (CSV le) on your PC.
5.
Open the e
xported template le and enter the required
informaon of the devices to be added
on the corresponding column.
Note
For detailed descripon of the required elds, refer to the introducons in the template.
DS-K5671B Series Face Recognion Terminal User Manual
132