User's Manual

Figure 8-12 Access Control and Elevator Control
2.
Check Enable Ele
vator Control.
3.
Set the elevator parameters.
Elevator No.
Select an elevator No. for conguraon from the drop-down list.
Ele
vator Controller Type
Select an elevator controller from the drop-down list.
Interface Type
Select a communicaon type from the drop-down list for elevator communicaon.
If you select R
S-485, make sure you have connected the device to the elevator controller with
RS-485 wire.
If you select Network Interface, enter the elevator controller's IP address, port No., user
name, and password for communicaon.
Neg
ave Floor Capacity
Set the
negave oor number.
Note
●
Up t
o 4 elevator controllers can be connected to 1 device.
●
Up to 10 negave oors can be added.
●
Make sure the interface types of elevator controllers, which are connected to the same
device, are consistent.
Set RS-485 Parameters
You can set the RS-485 parameters including the peripheral, address, baud rate, etc.
DS-K5671B Series Face Recognion Terminal User Manual
116