User's Manual

9.9.2 Check Real-Time Access Records
The access records will display in real me, including card swiping records, face recognions
records, ngerprint comparison records, etc. You can view the person informaon and view the
pictur
e captured during access.
Steps
1.
Click Monitoring and select a group from the drop-down list on the upper-right corner.
The access records triggered at the doors in the selected group will display in real me. You can
vie
w the details of the records, including card No., person name, organizaon, event me, etc.
2.
Oponal: Check the event type and event status so that these events will show in the list if the
events are detected. The events of unchecked type or status will not be displayed in the list.
3.
Oponal: Check Show Latest Event and the latest access record will be selected and displayed at
the top of the record list.
4.
Oponal: Click the event to view the accessed person details, including person pictures
(captured picture and prole), person No., person name, organizaon, phone, contact address,
etc.
Note
You can double click the captured picture to enlarge it to view the details.
5.
Oponal: Righ
t click on the column name of the access event table to show or hide the column
according to actual needs.
9.10 Event Center
The event informaon (for example, device oine) received by the client displays. In the Event
Center, you can check the detailed informaon of the real-me and historical events, view the
e
vent linked video, handle the events, and so on.
Before the client can receive the event informaon from the device, you need to enable the events
of the resource and arm the device rst. For details, refer to
Enable Receiving Event from Devices .
Be
fore the you can view the pop-up alarm informaon, you need to enable event triggered pop-up
image in the event center. For details, refer to .
9.10.1 Enable Receiving Event from Devices
Before the client
soware can receive event nocaons from the device, you need to arm the
device
rst.
Steps
1.
Click
→ Tool → De
vice Arming Control to open Device Arming Control page.
All the added devices appear on this page.
2.
In the Auto-Arming column, turn on the switch to enable auto-arming.
DS-K1T681 Series Face
Recognion Terminal User Manual
178