User's Manual

Steps
Note
It should be supported by the device.
1.
Click Access Con
trol → Linkage Conguraon .
2.
Select the access control device from the list on the le.
3.
Click Add buon to add a new linkage.
4.
Select the event source as Card Linkage.
5.
Enter the card number or select the card from the drop-down list.
6.
Select the card reader where the card swipes to trigger the linked acons.
7.
In the Linkage Target area, set the property target to enable this acon.
Buzzer on Controller
The audible warning of access control device will be triggered.
Capture
The real-me capture will be triggered.
Access Point
The door status of open, close, remain open, or remain closed will be triggered.
8.
Click Save.
When the card (congured in Step 5) swipes on the card reader (congured in Step 6), it can
trig
ger the linked acons (congured in step 7).
9.
Oponal: Aer adding the device linkage, you can do one or more of the following:
Delete Linkage
Sengs
Select the
congured linkage sengs in the device list and click Delete to
delete it.
Edit Linkage
Sengs
Select the
congured linkage sengs in the device list and you can edit its
event source parameters, including event source and linkage target.
9.8.4 Congure Device Acons for Person ID
You can set the access control device's linkage acons for the specied person ID. When access
c
ontrol device detects the specied person ID, it can trigger buzzer on card reader, and other
acons.
Steps
Note
It should be supported by the device.
1.
Click Access Con
trol → Linkage Conguraon .
2.
Select the access control device from the list on the le.
3.
Click Add t
o add a new linkage.
DS-K1T681 Series Face
Recognion Terminal User Manual
175