User's Manual

Set Triggered Capture Parameters
When an event occurs, the camera of the access control device can be triggered to capture
picture(s) to record what happens when the event occurs. You can view the captured pictures
when checking the event details in Event Center. Before that, you need to set the parameters for
the capture such as number of pictures captured for one me.
Before You Start
Before seng the capture parameters, you should set the picture storage rst to dene where the
captured pictures are saved. For details, refer to Set Picture Storage in the user manual of the
client soware.
Steps
Note
This funcon should be supported by the device
1.
En
ter the Access Control module.
2.
On the navigaon bar on the le, enter Advanced Funcon → More Parameters → Capture .
3.
Select an access control device in the device list and select Linked Capture.
4.
Set the picture size and quality.
5.
Set the capture mes once triggered which denes how many pictures will be captures for one
me.
6.
If the c
apture mes is more than 1, set the interval for each capture.
7.
Click Save.
Set Manual Capture Parameters
In Status Monitoring module, you can capture a picture manually the access control device's
camera by clicking a
buon. Before that, you need to set the parameters for the capture such as
picture quality.
Before You Start
Before seng the capture parameters, you should set the saving path rst to dene where the
c
aptured pictures are saved. For details, refer to Set Picture Storage in the user manual of the
client soware.
Steps
Note
This funcon should be supported by the device
1.
En
ter the Access Control module.
2.
On the navigaon bar on the le, enter Advanced Funcon → More Parameters → Capture .
3.
Select an access control device in the device list and select Manual Capture.
DS-K1T681 Series Face Recognion Terminal User Manual
169