User's Manual

Note
●
The main channel and the back
up channel cannot enable N1 or G1 at the same me.
●
N1 refers to wired network and G1 refers to GPRS.
7.
Click Sa
ve.
Create ISUP Account in Wired Communicaon Mode
You can set the account for ISUP protocol in wired communicaon mode. Then you can add
devices via ISUP protocol.
Steps
Note
This funcon should be supported by the device.
1.
En
ter the Access Control module.
2.
On the navigaon bar on the le, enter Advanced Funcon → More Parameters .
3.
Select an access control device in the device list and enter Network → Network Center .
4.
Select the center group from the drop-down list.
5.
Select the Address Type as IP Address or Domain Name.
6.
Enter IP address or domain name according to the address type.
7.
Enter the port number for the protocol.
Note
The port number of the wireless network and wired network should be consistent with the port
number of ISUP
.
8.
Select the Pr
otocol Type as ISUP.
9.
Set an account name for the network center.
10.
Click Save.
Set Device Capture Parameters
You can congure the capture parameters of the access control device, including manual capture
and event triggered capture.
Note
●
The c
apture funcon should be supported by the device.
●
Before seng the capture parameters, you should set the picture storage rst to dene where
the event triggered pictures are saved. For details, refer to Set Picture Storage in the user
manual of the client soware. .
DS-K1T681 Series Face Recognion Terminal User Manual
168