User's Manual

9.7.7 Congure Mul-door Interlocking
You can set the mul-door interlocking between mulple doors of the same access control device.
To open one of the doors, other doors must keep closed. That means in the interlocking combined
door group, up to one door can be opened at the same me.
Before You Start
Add access control device to the client, and make sure the device supports the mul-door
interlocking funcon.
Steps
Note
●
Mul-door Interlocking funcon is only supported by the access control device which has more
than one access c
ontrol points (doors).
●
Either the an-passing back or mul-door interlocking funcon can be congured for an access
control device at the same me. For the conguraon of an-passing back funcon, refer to
Congure An-Passback .
1.
Click Access Con
trol → Advanced Funcon → Mul-door Interlocking .
2.
Select an access control device on the le panel.
3.
Click Add on the Mul-door Interlocking List panel to open Add Access Control Point to open the
Add windo
w.
4.
Select at least two access control points(doors) from the list.
Note
Up to four doors can be added in one mul-door interlocking combinaon.
5.
Click OK t
o add the selected access control point(s) for interlocking.
The
congured mul-door interlocking combinaon will list on the Mul-door Interlocking List
panel.
6.
Oponal: Select an added mul-door interlocking combinaon from the list and click Delete to
delete the combinaon.
7.
Click Apply t
o apply the sengs to the access control device.
9.7.8 Congure Device Parameters
Aer adding the access control device, you can set its parameters such as network parameters.
Set Mulple NIC Parameters
If the device supports mulple network interfaces, you can set the network parameters of these
NICs via the client, such as IP address, MAC address, port number, etc.
DS-K1T681 Series Face Recognion Terminal User Manual
166