User's Manual

If the person is set as a super user, he/she will have authorizaon to access all the doors/
oors and will be exempted from remaining closed restricons, all an-passback rules, and
rst person authorizaon.
Extended Door Open Time
Use this funcon for persons with reduced mobility. When accessing the door, the person will
have more me than others to pass through doors.
For details about seng the door's open duraon, refer to Congure Parameters for Door/
Elevator .
Add to Blocklist
Add the person to the blocklist and when the person tries to access doors/oors, an event
will be triggered and sent to the client to nofy the security personnel.
Mark as Visitor
If the person is a visitor, you should set the her/his valid mes for visit.
Note
The valid mes for visit is between 1 and 100. You can also check No Limit, then ther
e are no
limited mes for the visitor to access doors/oors.
Device Operator
F
or person with device operator role, he/she is authorized to operate on the access control
devices.
Note
The Super User, Extended Door Open Time, Add to Blocklist, and Mark as Visitor funcons
cannot be enabled concurrently. For example, if one person is set as super user, you cannot
enable e
xtended door open me for her/him, add her/him to the blocklist, or set her/him as
visitor.
6.
Conrm to add the person.
-
Click Add t
o add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons.
9.4.10 Customize Person Informaon
You can customize the person properes which are not pre-dened in the client according to actual
needs, e.
g., place of birth. Aer customizing, when add a person, you can enter the custom
informaon to make the person informaon complete.
Steps
1.
Enter Person module.
2.
Set the elds of custom informaon.
1) Click Cus
tom Property.
2) Click Add to add a new property.
DS-K1T681 Series Face Recognion Terminal User Manual
140