User's Manual

11.
Oponal: Perform the following operaon(s).
Remote
Conguraon
Click on Operaon column to set remote conguraon of the
c
orresponding device.
Note
For detail operaon steps for the remote conguraon, see the user
manual of the de
vice.
Device Status Click on
Operaon column to view device status, including
cameras, recording status, signal status, hardware status, etc.
Edit Device
Informaon
Click
on Operaon column to edit the device informaon,
such as IP address, user name, and password.
Check Online User Click on Operaon column to check the online users who
access the device, such as user name, user type, user's IP address,
and login me.
Refresh Click on Operaon column to get the latest device
informaon.
Delete Device Select one or mulple devices and click Dele
te to delete the
selected device(s) from the client.
Add Device by ISUP Account
For access control devices supports ISUP 5.0 protocol, you can add them to the client by ISUP
protocol aer entering device ID and key, if you have congured their server addresses, port No.,
and device IDs.
Before You Start
Make sure the devices have connected to the network properly.
Steps
1.
Enter Device Management module.
The added devices are displayed on the right panel.
2.
Click Add to open the Add window.
3.
Select ISUP as the adding mode.
4.
Enter the required informaon.
Device Account
En
ter the account name registered on ISUP protocol.
ISUP Key
For ISUP 5.0 devices, enter the ISUP key if you have set it when conguring network center
parameter for the device.
DS-K1T681 Series Face Recognion Terminal User Manual
124