User's Manual

2) Set the IP address, subnet mask, and default gateway. Or check Enable DHCP and the system
will allocate the IP address, subnet mask, and default gateway automacally.
5. Click Sa
ve.
Report Strategy Sengs
You can set the center group for uploading the log via the ISUP protocol.
On the Device for Management page, click
→ Network → R
eport Strategy to enter the Report
Strategy Sengs tab.
You can set the center group and the system will transfer logs via ISUP protocol. Click Save to save
the sengs.
Center Group
Select a cen
ter group from the drop-down list.
Main Channel/Backup Channel
The device will communicate with the center via the main channel. When excepon occurs in
the main channel, the device and the center will communicate with each other via the backup
channel.
Note
• N1 refers to wired network and G1 refers to GPRS.
•
Only device with 3G/4G funcon supports seng the channel as G1.
Set ISUP Parameters
Set the ISUP parameters for accessing device via ISUP protocol.
St
eps
Note
The
funcon should be supported by the device.
1. Click Conguraon → Ne
twork → Advanced Sengs → Plaorm .
2. Select ISUP from the plaorm access mode drop-down list.
3. Check Enable.
4. Se
t the ISUP version, server address, device ID, and the ISUP status.
Note
If you select 5.0 as the version, you should set the ISUP key as well.
5. Click Sa
ve.
DS-K1T680 Series Face Recognion Terminal User Manual
68