User's Manual

3. Tap the Employee ID. eld and edit the employee ID.
Note
• The employee ID should be less than 32 characters. And it can be a combinaon of lower
leers, upper
leers, and numbers.
• The employee ID should not be duplicated.
4. T
ap the Name eld and input the user name on the so keyboard.
Note
• Numbers, upper case leers, lower case leers,
and special characters are allowed in the user
name.
• The suggested user name should be within 32 characters.
5. T
ap the Password to view the password.
Note
The password cannot be edited. It can only be applied by the plaorm.
6. Se
t the user role.
Administrator
The user is the administrator. Except for the normal aendance funcon, the user can also
enter the Home page to operate aer
authencang the permission.
Normal User
The User is the normal user. The user can only authencate or take aendance on the inial
page.
7. Tap
to save the
sengs.
7.3.6 Set Authencaon Mode
Aer adding the user's face picture, password, or other credenals, you should set the
authencaon mode and the user can authencate his/her identy via the congured
authencaon mode.
St
eps
1. Long tap on the inial page for 3 s and slide to the le/right by following the gesture and log in
the backend.
2. Tap User → Add User/Edit User → Authencaon Mode .
3. Select Device or Custom as the authencaon mode.
De
vice
If you want to select device mode, you should set the terminal authencaon mode in
Access Control Sengs page rst. For details see Seng Access Control Parameters.
DS-K1T680 Series Face Recognion Terminal User Manual
42