User's Manual

Note
• For details about adding a face picture, see Add F
ace Picture .
•
Note
For details about adding a ngerprint, see Add Fingerprin
t .
• For details about adding a card, see Add Card .
•
For details about adding a password, see View Password .
6. Oponal: Se
t the administrator's authencaon type.
Note
For details about seng the
authencaon type, see Set Authencaon Mode .
7. Enable the Adminis
trator Permission funcon.
Enable Administrator Permission
The user is the administrator. Except for the normal aendance funcon, the user can also
enter the Home page to operate aer authencang the permission.
8. Tap
to save the
sengs.
7.3.2 Add Face Picture
Add user's face picture to the device. And the user can use the face picture to authencate.
Steps
1. Long t
ap on the inial page for 3 s and slide to the le/right by following the gesture and log in
the backend.
2. Tap User → + to enter the Add User page.
3. Edit the employee ID.
Note
• The employee ID should be less than 32 characters. And it can be a combinaon of lower
leers, upper
leers, and numbers.
• The employee ID should not be duplicated.
4. T
ap the Name eld and input the user name on the so keyboard.
Note
• Numbers, upper case leers, lower case leers,
and special characters are allowed in the user
name.
• The suggested user name should be within 32 characters.
5. T
ap the Face Picture eld to enter the face picture adding page.
DS-K1T680 Series Face
Recognion Terminal User Manual
37