User's Manual

Chapter 4 Wiring

The device supports connecng to the RS-485 terminal, the door lock, the exit buon, the alarm

output/input devices, the Wiegand card reader, the access controller, and the power supply. You

can wire the peripherals according to the descripons below.

If connect the Wiegand card reader with the access controller, the face recognion terminal can

transmit the authencaon informaon to the access controller and the access controller can

judge whether to open the door or not.

Note

• If the cable size is 18 AWG, you should use a 12 V switched-mode power supply. And the

dis

tance between the power supply and the device should be no more than 20 m.

• If the cable size is 15 AWG, you should use a 12 V switched-mode power supply. And the

distance between the power supply and the device should be no more than 30 m.

• If the cable size is 12 AWG, you should use a 12 V switched-mode power supply. And the

distance between the power supply and the device should be no more than 40 m.

4.1 Terminal

Descripon

The terminals contains power input, alarm input, alarm output, RS-485, Wiegand output, and door

lock.

The t

erminal's diagram is as follows:

DS-K1T680 Series Face

Recognion Terminal User Manual