User's Manual

Note
The remain open duraon should be between 0 and 1440 minutes. By default, the remain
open duraon is 10 minutes.
Disable Remaining Open aer First Person
Disable the funcon of rst person in, namely normal authencaon.
Note
You can authencate by the rst person again to disable the rst person mode.
4. Click Add on the Fir
st Person List panel.
5. Select person(s) in the le list and the person(s) will be add to the selected persons as the rst
person(s) of the doors.
The added rst person(s) will list in the First Person List
6. Oponal: Select a rst person from the list and click Delete to remove the person from the rst
person list.
7. Click Save.
9.7.6 Congure
An-Passback
You can set to only pass the access control point according to the specied path and only one
per
son could pass the access control point aer swiping the card.
Before You Start
Enable the an-passing back funcon of the access control device.
P
erform this task when you want to congure the an-passing back for the access control device.
Steps
Note
Either the an-passing back or mul-door interlocking funcon can be congured for an access
c
ontrol device at the same me. For the conguraon of mul-door interlocking, refer to
Congure Mul-door Interlocking .
1. Click Access Con
trol → Advanced Funcon → An-Passback to enter the an-passing back
conguraon page.
2. Select an access c
ontrol device in the list.
3. Select a card reader as the beginning of the path in the First Card Reader eld.
4. Click the t
ext eld of the selected rst card reader in the Card Reader Aerward column to
open Select Card Reader dialog.
5. Select the aerward card readers for the rst card reader.
DS-K1T680 Series Face Recognion Terminal User Manual
123