User's Manual

Table Of Contents
Note
This funcon should be supported by the device.
Y
ou can log into the device to get the cercate le by web browser.
7.
Check S
ynchronize Time to synchronize the device me with the PC running the client aer
adding the device to the client.
8.
Oponal: Check Import to Group to create a group by the device name.
9.
Finish adding the device.
-
Click Add to add the device and back to the device list page.
-
Click Add and New to save the sengs and connue to add other device.
10.
Oponal: Perform the following operaon(s).
Remote
Conguraon
Click
on Operaon column to set remote conguraon of the
c
orresponding device.
Note
For detail operaon steps for the remote conguraon, see the user
manual of the de
vice.
Device Status Click on Operaon column to view device status, including
c
ameras, recording status, signal status, hardware status, etc.
Edit Device
Informaon
Click
on Operaon column to edit the device informaon, such as
IP addr
ess, user name, and password.
Check Online User Click
on Operaon column to check the online users who access
the de
vice, such as user name, user type, user's IP address, and
login me.
Refresh Click
on Operaon column to get the latest device informaon.
Delete Device Select one or mulple devices and click Dele
te to delete the
selected device(s) from the client.
Add Device by EHome Account
For access control devices supports EHome 5.0 protocol, you can add them to the client by EHome
protocol aer entering device ID and key, if you have congured their server addresses, port No.,
and de
vice IDs.
Before You Start
Make sure the devices have connected to the network properly.
Steps
1.
Enter Device Management module.
The added devices are displayed on the right panel.
2.
Click Add to open the Add window.
DS-K6300 Series Payment Terminal User Manual
81