User's Manual

Table Of Contents
2.
Select the Plaorm Access Mode.
Note
Hik-Connect is an applicaon for mobile devices. With the App, you can view live image of the
de
vice, receive alarm nocaon and so on.
3.
Check the checkbo
x of Enable to enable the funcon.
4.
Oponal: Check the checkbox of Custom, and you can set the server address by yourself.
5.
Create a Stream Encrypon/Encrypon Key for the device.
Note
6 to 12
leers (a to z, A to Z) or numbers (0 to 9), case sensive. You are recommended to use a
combinaon of no less than 8 leers or numbers.
6.
Click Sa
ve to enable the sengs.
Congure HTTP Listening
The device can send alarm informaon to the event alarm IP address or domain name via HTTP
protocol/HTTPS protocol.
Before You Start
The event alarm IP address or domain name should support the HTTP protocol/HTTPS protocol to
receive the alarm informaon.
Note
The
funcon should be supported by the device.
Steps
1.
Click Conguraon → Ne
twork → Advanced → HTTP Listening .
2.
Edit the event alarm IP address or domain name, URL, port, and protocol.
3.
Oponal: Click De
fault to reset the event alarm IP address or domain name.
4.
Click Save.
9.5.12 Set Video and Audio Parameters
Set the image quality, resoluon, and the device volume.
Set Video Parameters
Click Conguraon → Video/Audio → Video .
Set the video channel, camera name, stream type, the video type, the bitrate type, the frame rate,
the Max. bitrate, the video encoding, and I Frame Interval.
Click Save to save the sengs aer the
conguraon.
DS-K6300 Series Payment Terminal User Manual
67