User's Manual

Table Of Contents
2.3 Mount With Cylinder Bracket
2.3.1 Preparaon before Mounng with Bracket
Make sure you have drilled holes on the turnsle. If not, follow the steps below to drill holes.
St
eps
1.
Use 4 screws (M3 or M4), secured by ange nuts, to install the reinforcing board on the inner
surf
ace of the turnsle.
Note
The distance between the turnsle and the edge should be no longer than 10 mm.
2.
Drill holes on the turnsle's inner surface according to the gure displayed below. And install
w
ater-proof nut.
DS-K6300 Series Payment Terminal User Manual
9