User's Manual

Edit Linkage
Sengs
Select the
congured linkage sengs in the device list and you can edit its
event source parameters, including event source and linkage target.
10.8.4 Congure Device Acons for Person ID
You can set the access control device's linkage acons for the specied person ID. When access
control device detects the specied person ID, it can trigger buzzer on card reader, and other
acons.
Steps
Note
It should be supported by the device.
1.
Click Access Con
trol → Linkage Conguraon .
2.
Select the access control device from the list on the le.
3.
Click Add to add a new linkage.
4.
Select Person Linkage as the event source.
5.
Enter the employee number or select the person from the drop-down list.
6.
Select the card reader where the card swipes.
7.
In the Linkage Target area, set the property target to enable this acon.
Buzzer on Controller
The audible w
arning of access control device will be triggered.
Buzzer on Reader
The audible warning of card reader will be triggered.
Capture
An event-related picture will be captured when the selected event happens.
Recording
An event-related picture will be captured when the selected event happens.
Note
The device should support recording.
Access Point
The door s
tatus of open, close, remain open, or remain closed will be triggered.
8.
Click Save.
9.
Oponal:
Aer adding the device linkage, you can do one or more of the followings:
Delete Linkage
Sengs
Select the
congured linkage sengs in the device list and click Delete to
delete it.
DS-K6300 Series Payment Terminal User Manual
132