User's Manual

Table Of Contents
Note
The target door and the source door cannot be the same one.
7.
Click Sa
ve.
8.
Oponal: Aer adding the device linkage, you can do one or more of the following:
Edit Linkage
Sengs
Select the
congured linkage sengs in the device list and you can edit its
event source parameters, including event source and linkage target.
Delete Linkage
Sengs
Select the
congured linkage sengs in the device list and click Delete to
delete it.
10.8.3 Congure Device Acons for Card Swiping
You can set the access control device's linkage acons for the specied card swiping. When you
swipe the specied card, it can trigger the host buzzer, and other acons on the same device.
Steps
Note
It should be supported by the device.
1.
Click Access Con
trol → Linkage Conguraon .
2.
Select the access control device from the list on the le.
3.
Click Add buon to add a new linkage.
4.
Select the event source as Card Linkage.
5.
Enter the card number or select the card from the drop-down list.
6.
Select the card reader where the card swipes to trigger the linked acons.
7.
In the Link
age Target area, set the property target to enable this acon.
Buzzer on Controller
The audible w
arning of access control device will be triggered.
Capture
The real-me capture will be triggered.
Access P
oint
The door status of open, close, remain open, or remain closed will be triggered.
8.
Click Save.
When the card (congured in Step 5) swipes on the card reader (congured in Step 6), it can
trig
ger the linked acons (congured in step 7).
9.
Oponal: Aer adding the device linkage, you can do one or more of the following:
Delete Linkage
Sengs
Select the
congured linkage sengs in the device list and click Delete to
delete it.
DS-K6300 Series Payment Terminal User Manual
131