User's Manual

Table Of Contents
5.
Set the capture mes once triggered which denes how many pictures will be captures for one
me.
6.
If the capture mes is more than 1, set the interval for each capture.
7.
Click Save.
Set Manual Capture Parameters
In Status Monitoring module, you can capture a picture manually the access control device's
camera by clicking a buon. Before that, you need to set the parameters for the capture such as
picture quality.
Before You Start
Before seng the capture parameters, you should set the saving path rst to dene where the
captured pictures are saved. For details, refer to Set Picture Storage in the user manual of the
client soware.
Steps
Note
This funcon should be supported by the device
1.
En
ter the Access Control module.
2.
On the navigaon bar on the le, enter Advanced Funcon → More Parameters → Capture .
3.
Select an access control device in the device list and select Manual Capture.
4.
Select the resoluon of the captured pictures from the drop-down list.
5.
Select the pictur
e quality as High, Medium, or Low. The higher the picture quality is, the larger
size the picture will be.
6.
Click Save.
Set Parameters for Face Recognion Terminal
For face recognion terminal, you can set its parameters including face picture database, QR code
authencaon, etc.
St
eps
Note
This funcon should be supported by the device.
1.
En
ter the Access Control module.
2.
On the navigaon bar on the le, enter Adv
anced Funcon → More Parameters .
3.
Select an access control device in the device list and click Face Recognion Terminal.
4.
Set the parameters.
DS-K6300 Series Payment Terminal User Manual
126