User's Manual

The alarm can be triggered if the door has not been closed in a congured me period. If it is
set as 0, no alarm will be triggered.
Duress Code
The door can open by inpung the duress code when there is duress. At the same me, the
client can report the duress event.
Super Password
The specic person can open the door by inpung the super password.
Note
●
The dur
ess code and the super code should be dierent.
●
The duress code and the super password should be dierent from the authencaon
password.
●
The length of duress code and the super password is according the device, usually it should
contains 4 to 8 digits.
5.
Click OK.
6.
Oponal: Click Cop
y to , and then select the door to copy the parameters in the page to the
selected doors.
Note
The door's status duraon
sengs will be copied to the selected door(s) as well.
Congure Parameters for Card Reader
Aer adding the access control device, you can congure its card reader parameters.
St
eps
1.
Click Access Control → Advanced Funcon → De
vice Parameter .
2.
In the device list on the le, click
to expand the door, select a card reader and you can edit the
c
ard reader's parameters on the right.
3.
Edit the card reader basic parameters in the Basic Informaon page.
Note
●
The displa
yed parameters may vary for dierent access control devices. There are part of
parameters listed as follows. Refer to the user manual of the device for more details.
●
Some of the following parameters are not listed in the Basic Informaon page, click Advanced
to edit the parameters.
Basic Informaon
Name
E
dit the card reader name as desired.
Minimum Card Swiping Interval
DS-K6300 Series Payment Terminal User Manual
111