User's Manual

Table Of Contents
Congure Parameters for Access Control Device
Aer adding the access control device, you can congure its parameters, including overlaying user
informaon on picture, uploading pictures aer capturing, saving captured pictures, etc.
St
eps
1.
Click Access Control → Advanced
Funcon → Device Parameter .
Note
If you can nd Device Parameter in the Advanced Funcon list, Hover the cursor on the
Adv
anced Funcon, and then Click
to select the Device Parameter to be displayed.
2.
Select an access de
vice to show its parameters on the right page.
3.
Turn the switch to ON to enable the corresponding funcons.
Note
The displa
yed parameters may vary for dierent access control devices.
Some of the following parameters are not listed in the Basic Informaon page, click More to
edit the parameters.
Voice Prompt
If y
ou enable this funcon, the voice prompt is enabled in the device. You can hear the voice
prompt when operang in the device.
Upload Pic. Aer Linked Capture
Upload the pictur
es captured by linked camera to the system automacally.
Save Pic. Aer Linked Capture
If y
ou enable this funcon, you can save the picture captured by linked camera to the device.
Face Recognion Mode
Normal Mode
Recognize face via the camera normally.
Deep Mode
The device can recognize a much wider people range than the normal mode. This mode is
applicable to a more complicated environment.
Enable NFC Card
If enable the funcon, the device can recognize the NFC card. You can present NFC card on
the de
vice.
Enable M1 Card
If enable the funcon, the device can recognize the M1 card. You can present M1 card on the
de
vice.
Enable EM Card
DS-K6300 Series Payment Terminal User Manual
109