User's Manual

Note
If you select the enrollment staon, you should click Login t
o set related parameters of the
device including IP address, port No., user name, and password. Also, you can check Face An-
Spoong and select the liveness level as Low, Medium, or High.
Face An-Spoong
If you check this funcon, then the device can detect whether the face to be collected is an
authenc one.
6.
Collect f
ace.
1) Face to the camera of the selected access control device and make sure your face is in the
middle of the collecng window.
2) Click
to capture a photo.
3)
Click OK to save the captured photo.
7.
Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons .
10.4.7 Collect Fingerprint via Client
Collecng ngerprints locally means you can collect the ngerprint via the ngerprint recorder
connected directly to the PC running the client. The ngerprints recorded can be used as
credenals of the persons to access the authorized doors.
Before You Start
Connect the ngerprint recorder to the PC running the client.
St
eps
1.
Enter Person module.
2.
Select an organizaon in the organizaon list to add the person and click Add.
Note
Enter the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Basic Informaon .
3.
In the
Credenal → Fingerprint panel, click +.
4.
In the pop-up window, select the collecon mode as Loc
al.
5.
Select the model of the connected ngerprint recorder.
Note
If the
ngerprint recorder is DS-K1F800-F, you can click Sengs to select the COM the
ngerprint recorder connects to.
6.
Collect the ngerprint.
1) Click St
art.
2) Place and li your ngerprint on the ngerprint recorder to collect the ngerprint.
DS-K6300 Series Payment Terminal User Manual
93