User's Manual

2. Edit the
desnaon IP or host name, URL and port.
3. Oponal: Click Test to test whether the entered IP address or host name are valid.
4.
Oponal: Click Default to reset the desnaon IP or host name.
5. Click Save.
Set Wi-Fi Parameters
Set the Wi-Fi parameters for device wireless connecon.
Steps
Note
The funcon should be supported by the device.
1. Click Conguraon → Network → Basic Sengs → Wi-Fi .
Figure 8-7 Wi-Fi Sengs Page
2. Check Wi-Fi.
3. Select a Wi-Fi
-
Click of a Wi-Fi in the list and enter the Wi-Fi password.
-
Click Add and enter a Wi-Fi's name, password, and
encrypon type. Click Connect. When the
Wi-Fi is connected, click OK.
4.
Oponal: Set the WLAN parameters.
1) Click TCP/IP
Sengs.
2) Set the IP address, subnet mask, and default gateway. Or check Enable DHCP and the system
will allocate the IP address, subnet mask, and default gateway automacally.
5. Click Save.
8.5.13 Set Video and Audio Parameters
Set the image quality, resoluon, and the device volume.
Face Recognion Terminal User Manual
74