User's Manual

7.2 Communicaon Sengs
You can set the network parameters, the Wi-Fi parameter, the RS-485 parameters, the Wiegand
parameters, and the plaorm access on the communicaon sengs page.
Note
Wi-Fi funcon may vary according to dierent models. Please refer to the actual device.
7.2.1 Set Wired Network Parameters
You can set the device wired network parameters, including the IP address, the subnet mask, the
gateway, and DNS parameters.
Steps
1. Tap Comm.
(Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2. On the
Communicaon Sengs page, tap Wired Network.
Figure 7-4 Wired Network Sengs
3. Set IP Address, Subnet Mask, and Gateway.
-
Enable DHCP, and the system will assign IP address, subnet mask, and gateway
automacally.
-
Disable DHCP, and you should set the IP address, subnet mask, and gateway manually.
Face Recognion Terminal User Manual
35