User's Manual

• If you do not
congure the applicaon mode and tap Next, the system will select Indoor by
default.
• If you acvate the device via other tools remotely, the system will select Indoor as the
applicaon mode by default.
6.3 Set Network Parameters
Aer acvaon and select applicaon mode, you can set the network for the device
Steps
1. Set the wired network parameters.
-
If enable DHCP, the system will assign the IP address and other parameters automacally.
-
If disable DHCP, you should set the IP address, the subnet mask, and the gateway.
Note
Make sure the device has connected to a network.
2. Tap Next.
3. Oponal: Tap Skip to skip network sengs.
6.4 Set Administrator
Aer device acvaon, you can add an administrator to manage the device parameters.
Before You Start
Acvate the device and select an applicaon mode.
Steps
1.
Oponal: Tap Skip to skip adding administrator if required.
2. Enter the administrator's name (oponal) and tap Next.
Face Recognion Terminal User Manual
28