User's Manual

If you enable this funcon, the captured pictures will be saved.
Temperature Measurement Only
When enabling the funcon, the device will not authencate the permissions, but only take
the temperature. When disabling the funcon, the device will authencate the permissions
and at the same me take the temperature.
Capture White Light Picture
When enabling the funcon, the pictures captured by the white light camera will be
uploaded to the
plaorm. If disabling the funcon, the device will only upload pictures
captured by thermographic camera to the plaorm.
Door Not Open When Detecng Abnormal Temperature
When enabling the funcon, the door will not open when the detected temperature is
higher or lower than the
congured temperature threshold. By default, the temperature is
enabled.
Must Wear Face Mask
Aer enabling this funcon, the authencated person must wear a face mask, otherwise the
authencaon will be failed.
Over-Temperature Alarm
Edit the threshold according to actual situaon. If the detected temperature is higher than
the congured parameters, an alarm will be triggered. The value should be between 35.1 ℃
and 44.9 ℃.
3. Click Save.
9.14.13 Set Face
Recognion Terminal Parameters
Click Maintenance and Management → Device to enter the device list.
Press CTRL and click to enter the remote conguraon page.
Click Other → Face Recognion Terminal Parameters and you can congure the device
parameters.
Face Picture Database
Select Deep Learning as the face picture database.
Save
Authencang Face Picture
If enabled, the captured face picture when
authencang will be saved on the device.
CPU Card Reading
Select to read card No. or le.
Work Mode
Set the device work mode as Normal Mode. You should authencate your credenal for
accessing.
Face Recognion Terminal User Manual
192