User's Manual

9.12.5 Set File Saving Path
The pictures captured in Status Monitoring module are stored on the local PC. The saving path of
these
les can be set.
Steps
1. Open the System
Conguraon page.
2. Click File tab to enter the File Saving Path
Sengs page.
3. Click
and select a local path for the les.
4. Click Save.
9.12.6 Set Email Parameters
When an event is triggered, if you can set Send Email as linkage acon for this event, the client will
an email to the recipients for nocaon. You need to set the email sengs and specify target
recipients in this secon.
Steps
1. Enter the System Conguraon module.
2. Click Email tab to enter the Email
Sengs interface.
3. Enter the required informaon.
STMP Server
The STMP server IP address of host name (e.g., smtp.263xmail.com)
Encrypon Type
You can check the radio to select Non-Encrypted, SSL, or STARTTLS .
Port
Enter the communicaon port used for SMTP. The port is 25 by default.
Sender Address
The email address of the sender.
Security Cercate (Oponal)
If your email server requires authencaon, check this checkbox to use authencaon to log
into the server and enter the login user name and password of your email account.
User Name
Enter the user name of the sender email address if Server
Authencaon is checked.
Password
Enter the password of the sender Email address if Server Authencaon is checked.
Receiver 1 to 3
Enter the email address of the receiver. Up to 3 receivers can be set.
4. Oponal: Click Send Test Email to send an email to the receiver for test.
Face Recognion Terminal User Manual
184