User's Manual

level. You can set dierent work hour rates (1-10, can be a decimal) for three overme levels.
For example, your valid overme is one hour (in overme level 1), and the work hour rate of
overme level 1 is set as 2, then the work hours in the period will be calculated as 2 hours.
Overme Rule for Weekend
You can enable overme rule for weekend and set calculaon mode.
3. Click Save.
Congure Aendance Check Point
You can set the card reader(s) of the access control device as the aendance check point(s), so that
the authencaon on the card readers will be recorded for aendance.
Before You Start
• You have added access control device(s). For details, refer to Add Device .
• You have enabled T&A Status. For details, refer to Add General Timetable .
By default, all card readers of the added access control devices are set as start/end-work check
points. If you need to edit check point
funcon of card reader(s), you can perform the following
operaons.
Steps
1. Enter the Time &
Aendance module.
2. Click Aendance Sengs → Aendance Check Point to enter the aendance check point
sengs page.
3. Set Set All Card Readers as Check Points switch to o.
4. Check the desired card reader(s) as aendance check point(s) in the list below.
5. Set check point
funcon as Start/End-Work, Start-Work or End-Work.
Note
When selecng Start-Work or End-Work, the aendance status uploaded from the device will
be decided by the check point funcon you set here.
Start-Work
Aendance status uploaded from the device will all be calculated as Check-in.
End-Work
Aendance status uploaded from the device will all be calculated as Check-out.
Start/End-Work
Aendance status will be calculated as Check in/out according to the actual aendance
status on the device.
6. Click Set as Check Point.
The
congured aendance check point(s) are displayed on the right list.
7. Oponal: Aer seng aendance check points, and perform the following operaons.
Face Recognion Terminal User Manual
161