User's Manual

Congure Parameters for Door
Aer adding the access control device, you can congure its access point door parameters.
Steps
1. Click Access Control → Advanced
Funcon → Device Parameter .
2. Select an access control device on the
le panel, and then click to show the doors of the
selected device.
3. Select a door to show its parameters on the right page.
4. Edit the door parameters.
Note
The displayed parameters may vary for dierent access control devices.
•
• Some of the following parameters are not listed in the Basic
Informaon page, click Advanced
to edit the parameters.
Name
Edit the card reader name as desired.
Door Contact
You can set the door sensor as remaining closed or remaining open. Usually, it is remaining
closed.
Exit Buon Type
You can set the exit buon as remaining closed or remaining open. Usually, it is remaining
open.
Open
Duraon
Aer swiping the normal card and relay acon, the mer for locking the door starts working.
Super Password
The specic person can open the door by inpung the super password.
Door Le Open Timeout Alarm
The alarm can be triggered if the door has not been closed in a congured me period. If it is
set as 0, no alarm will be triggered.
Click Advanced to congure more parameters.
Extended Open
Duraon
The door contact can be enabled with appropriate delay aer person with extended accesss
needs swipes her/his card.
Duress Code
The door can open by inpung the duress code when there is duress. At the same me, the
client can report the duress event.
Face Recognion Terminal User Manual
131