User's Manual

Set the HTTPS for accessing the browser. Cercate is required when accessing.
Server
It refers to the port through which the client adds the device.
Set Wi-Fi Parameters
Set the Wi-Fi parameters for device wireless connecon.
Steps
Note
The funcon should be supported by the device.
1. Click Conguraon → Network → Basic Sengs → Wi-Fi .
Figure 8-7 Wi-Fi Sengs Page
2. Check Wi-Fi.
3. Select a Wi-Fi
-
Click of a Wi-Fi in the list and enter the Wi-Fi password.
-
Click Add and enter a Wi-Fi's name, password, and encrypon type. Click Connect. When the
Wi-Fi is connected, click OK.
4. Oponal: Set the WLAN parameters.
1) Click TCP/IP
Sengs.
2) Set the IP address, subnet mask, and default gateway. Or check Enable DHCP and the system
will allocate the IP address, subnet mask, and default gateway
automacally.
5. Click Save.
Report Strategy
Sengs
You can set the center group for uploading the log via the ISUP protocol.
Go to Conguraon → Network → Basic Sengs → Report Strategy .
DS-K1T643 Series Face Recognion Terminal User Manual
70