User's Manual

NFC An-Cloning
If you enable this funcon, you cannot use the cloned card for authencaon and further
enhance security.
4. Click OK.
5.
Oponal: Click Copy to, and then select the access control device(s) to copy the parameters in
the page to the selected device(s).
Congure Parameters for Door/Elevator
Aer adding the access control device, you can congure its access point (door or oor)
parameters.
Before You Start
Add access control device to the client.
Steps
1. Click Access Control → Advanced
Funcon → Device Parameter .
2. Select an access control device on the
le panel, and then click to show the doors or oors of
the selected device.
3. Select a door or
oor to show its parameters on the right page.
4. Edit the door or oor parameters.
Note
• The displayed parameters may vary for
dierent access control devices.
• Some of the following parameters are not listed in the Basic Informaon page, click More to
edit the parameters.
Name
Edit the card reader name as desired.
Door Contact
You can set the door sensor as remaining closed or remaining open. Usually, it is remaining
closed.
Exit
Buon Type
You can set the exit buon as remaining closed or remaining open. Usually, it is remaining
open.
Door Locked Time
Aer swiping the normal card and relay acon, the mer for locking the door starts working.
Extended Open Duraon
The door contact can be enabled with appropriate delay aer person with extended accesss
needs swipes her/his card.
Door
Le Open Timeout Alarm
DS-K1T643 Series Face Recognion Terminal User Manual
113