User's Manual

Steps
Note
Some device models do not support this funcon. Refer to the actual products when conguraon.
1.
Click
Conguraon → Access Control → Wiegand Sengs .
Figure 8-15 Wiegand Page
2. Check Wiegand to enable the Wiegand funcon.
3. Set a transmission direcon.
Input
The device can connect a Wiegand card reader.
Output
The can connect an external access controller. And the two devices will transmit the card No.
via Wiegand 26 or 34.
4. Click Save to save the
sengs.
Note
If you change the peripheral, and aer you save the device parameters, the device will reboot
automacally.
Set Face Recognion Parameters
You can set face recognion parameters for accessing.
Click Conguraon → Access Control → Face Recognion Parameters .
You can set Working Mode as Access Control Mode. The access control mode is the device normal
mode. You should
authencate your credenal for accessing.
DS-K1T643 Series Face Recognion Terminal User Manual
86