User Manual

62
II. Set Manual Port Mapping
Steps
1. Check Enable UPnP™, and choose a friendly name for the device, or you can use the default name.
2. Select the port mapping mode to Manual, and set the external port to be the same as the internal port.
3. Click Save.
What to do next
Go to the router port mapping settings interface and set the port number and IP address to be the same as those on the device. For
more information, refer to the router user manual.
Multicast is group communication where data transmission is addressed to a group of destination devices simultaneously. After
setting multicast, you can send the source data efficiently to multiple receivers.
Go to Configuration → Network → Basic Settings → Multicast for the multicast settings.
IP Address
It stands for the address of multicast host.
Stream Type
The stream type as the multicast source.
Video Port
The video port of the selected stream.
Audio Port
The audio port of the selected stream.
You can set the SNMP network management protocol to get the alarm event and exception messages in network transmission.
Before You Start
Before setting the SNMP, you should download the SNMP software and manage to receive the device information via SNMP port.
Steps
1. Go to the settings page: Configuration → Network → Advanced Settings → SNMP.
2. Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
Note
The SNMP version you select should be the same as that of the SNMP software.
And you also need to use the different version according to the security level required. SNMP v1 is not secure and SNMP v2
requires password for access. And SNMP v3 provides encryption and if you use the third version, HTTPS protocol must be enabled.
3. Configure the SNMP settings.
4. Click Save.
You can use the Dynamic DNS (DDNS) for network access. The dynamic IP address of the device can be mapped to a domain name