User Manual

If the amount of defective pixels in the image is comparatively small and accurate correction is needed, you can correct these pixels

manually.

Steps

1. Go to Configuration → Image → DPC.

2. Select the thermal channel.

3. Select manual mode.

4. Click the defective pixel on the image, then a cursor shows on the live view.

5. Click Up, Down, Left, Right to adjust the cursor position to the defective pixel position.

6. Click , then click to correct defective pixel.

Note

If multiple defective pixels need to be corrected, click after locating a defective pixel. Then after locating other pixels, click

to correct them simultaneously.

7. Optional: Click to cancel defective pixel correction.

You can overlay the images of two channels and view the image of two channels at the same time.

Steps

1. Select a channel number.

2. Select the picture in picture mode.

Normal Mode

Disable picture in picture mode.

Overlay Mode

Enable picture in picture mode. You can overlay the image of another channel in the current

channel.

3. Click Save.