User Manual

ManualsBrandsHIKVISION ManualsBuilding Technology & Smart LivingHIKVISION ISD-SMG318LT-F LAN IP Walk-thru metal detector 2688 x 1520 p
 
37 
 
Delay   
Select Manual. 
2. Click Manual Alarm to enable manual alarm output. 
3. Optional: Click Clear Alarm to disable manual alarm output. 
  Automatic Alarm 
Set the automatic alarm parameters, then the device triggers an alarm output automatically in the set arming schedule. 
Steps   
1. Set automatic alarm parameters. 
Alarm Output No.   
Select the alarm output No. according to the alarm interface connected to the external alarm device. 
Alarm Name   
Custom a name for the alarm output. 
Delay   
It refers to the time duration that the alarm output remains after an alarm occurs. 
2. Set the alarming schedule. For the information about the settings, see Set Arming Schedule. 
3. Click Copy to… to copy the parameters to other alarm output channels. 
4. Click Save. 
II. FTP/NAS/Memory Card Uploading 
If you have enabled and configured the FTP/NAS/memory card uploading, the device sends the alarm information to the FTP server, 
network attached storage and memory card when an alarm is triggered. 
Refer to Set FTP to set the FTP server. 
Refer to Set NAS for NAS configuration. 
Refer to Set Memory Card for memory card storage configuration. 
III. Send Email 
Check Send Email, and the device sends an email to the designated addresses with alarm information when an alarm event is detected.   
For email settings, refer to Set Email. 
Set Email 
When the email is configured and Send Email is enabled as a linkage method, the device sends an email notification to all designated 
receivers if an alarm event is detected. 
Before You Start   
Set the DNS server before using the Email function. Go to Configuration → Network → Basic Settings → TCP/IP for DNS settings. 
Steps   
1. Go to email settings page: Configuration → Network → Advanced Settings → Email. 
2. Set email parameters. 
1) Input the sender's email information, including the Sender's Address, SMTP Server, and SMTP Port. 
2) Optional: If your email server requires authentication, check Authentication and input your user name and password to log in 
to the server. 
3) Set the E-mail Encryption. 
●  When you select SSL or TLS, and disable STARTTLS, emails are sent after encrypted by SSL or TLS. The SMTP port should be 
set as 465. 
●  When you select SSL or TLS and Enable STARTTLS, emails are sent after encrypted by STARTTLS, and the SMTP port should 
be set as 25. 