User Manual

I. Measure Body Temperature in Thermal Channel

Steps:

1. Go to Configuration → Body Thermography → Body Thermography Configuration.

2. Select thermal channel.

3. Click Draw Area, then click the mouse on the black body in live view and save it.

4. Set the black body parameters.

 Emissivity: Set the emissivity of black body.

Note

Refer to the emissivity table for reference in the manual or online.

 Distance: The straight-line distance between the black body and the device.

 Temperature: Enter the temperature of the black body.

5. Set Environmental Temperature Mode. Auto and Manual are selectable. In auto mode, the device detects environment

temperature automatically. In manual mode, you should enter environment temperature manually.

6. Set the body temperature compensation parameters if you need to detect human body temperature instead of shell

temperature.

i. Enable body temperature compensation function.

ii. Select the compensation type.

iii. In auto mode, the device calculates compensation value automatically. If the detected body temperature is still inaccuracy,

you can set Manual Calibration value.

iv. In manual mode, you should enter Manual Calibration value, and corresponding compensation value displays in

Compensation Value field.

7. Click Save.

8. Set the arming schedule and linkage methods. For the information about arming schedule settings, see Set Arming Schedule.

For the information about linkage methods, see Linkage Method Settings.

II. Measure Face Temperature in Optical Channel

Steps:

1. Go to Configuration → Body Thermography → Body Thermography Configuration.

2. Select the optical channel.

3. Check Enable Face Detection to detect human faces, and measure the temperature in the scene.

4. Check Display Temperature to display the highest temperature of each detected face in live view.

5. Check Upload Captured Face Image to capture and upload the face image of the target. If face detection function is also enabled,

max. temperature of the face displays on the image.

Note

Refer to face capture section to set the corresponding parameters.