User Manual

26
2. Click .
3. Drag the mouse in the live view to draw the area. You can drag the corners of the red rectangle area to change its shape and size.
4. Right click the mouse to stop drawing.
5. Optional: Select one area and click to delete it.
6. Click Save.
After enable the manual thermography function of the device, you can click any position on the live view to show the real temperature.
Steps
1. Go toConfiguration → Local and select Display Temperature Info. as Yes.
2. Go toConfiguration → Temperature Measurement → Basic Settings.
3. Check Enable Temperature Measurement.
4. Click Save.
5. Go to live view interface and select thermal channel, click . Click any position on the interface to show the real temperature.
Steps:
1. Go to Configuration-->Temperature Measurement -->Body Thermography Configuration.
2. Select thermal channel.
3. Click Draw Area, then click the mouse on the black body in live view and save it.
4. Set the black body parameters.
 Emissivity: Set the emissivity of black body.
Note
Refer to the emissivity table for reference in the manual or online.
 Distance: The straight-line distance between the black body and the device.
 Temperature: Enter the temperature of the black body.
Note
If there is no black body in the scene, skip step 3 and 4 .
5. Set Environmental Temperature Mode. Auto and Manual are selectable. In auto mode, the device detects environment
temperature automatically. In manual mode, you should enter environment temperature manually.
6. Set the body temperature compensation parameters if you need to detect human body temperature instead of shell
temperature.
i. Enable body temperature compensation function.
ii. Select the compensation type.
iii. In auto mode, the device calculates compensation value automatically. If the detected body temperature is still inaccuracy,
you can set Manual Calibration value.
iv. In manual mode, you should enter Manual Calibration value, and corresponding compensation value displays in
Compensation Value field.
7. Click Save.
8. Set the arming schedule and linkage methods. For the information about arming schedule settings, see Set Arming Schedule.
For the information about linkage methods, see Linkage Method Settings.