User Manual

11
Note: Make the Receiving Coil (RX) away from the interference source. Make sure the interference level displayed on the environment
inspection indicator is less than 2.
Security Check Point Layout
The performance of the check point may be impacted by the following causes:
 Arrange the line of the waiting people. Make sure there is only one person in the detector for every check.
 Make sure the metal detector not interfere the operation of the detector.
 Additional baggage check to prevent false alarm
Side-by-Side Installation
Side-by-side operation refers to the operation of two or more detectors in close proximity to each other. With side-by-side operation,
the detector may interfere with each other. The level of interference depends on the distance between the detector and their
operating frequency and sensitivity.
The detector has different working frequency selection. The recommended operating frequency should be between F1 and F3.
According to the frequency combination of F1, F2 and F3, as well as the sensitivity, the minimum distance between the detectors is
about 35 cm. You can also use the band F4 and F5, but in this condition, compared with only using frequency F1, F2, F3, the minimum
distance can a bit bigger.
To meet the minimum distance, install the two receiving panel (Rx) and launch panel (Tx) (if possible, makes the distance between