Installation Guide

High Performance Event Detection Server • Installation Guide
8
Chapter 2 Installation
Install Power Supply Unit
Align power supply unit with the unit track.
Insert the rear side of power supply unit into node slots, and push it into the track until the
front side of power supply unit is parallel to rear panel of server.
Take Out Power Supply Unit
Push blue breech lock of power supply unit along left side of server, and drag out it by
gripping handle.
Drag out it until the whole power supply unit is token out.
Install Bracket
The bracket should be adaptive with sliding rail, and distance between two strip-shaped plate
metals with hole should be ranged from 660 mm~ 850 mm.
Install Inner Rail
Snap the back half of inner rail on snap lock in side wall of chassis, and guarantee the
installation holes are align with inner rail holes.
Fix the back half of inner rail to the device by 2 M4 countersunk screws.
Repeat above steps to install another side.
Install Inner Rail