User Manual

Network Traffic Camera • User Manual
22
will be controlled remotely by the computer through the network.
Go to Configuration > Device Configuration > System Configuration > Serial Ports.
Serial Ports Settings
Set the RS-485 and RS-232 parameters.
Click Save to save the settings.
Set Network Parameters
Purpose:
Network parameters settings must be properly set before you operate the device over network.
The device supports both the IPv4 and IPv6. Both versions can be set simultaneously without
conflicting to each other, and at least one IP version should be set.
Go to Configuration > Device Configuration > System Configuration > Network
Parameters.
Select Dual-NIC Mode.
 Dual-Network Backup: When one network fails, the other network can take over the
interrupted work in real time to ensure the normal operation of the system.
 Multi-Network Isolation: If network ports are in different segments, select Multi-
Network Isolation.
Set corresponding parameters.
 Route Advertisement: The device can have multiple IPv6 addresses, but the device interface
only shows the most suitable IPv6 address.