User Manual

Network Traffic Camera User Manual
47
Chapter 11 Capture Parameters
Configuration
Purpose:
You can configure flash light and vehicle feature on this page.
11.1 Configure Flash Light Parameters
Steps:
1. Go to Configuration > Device Configuration > Capture Parameters > Flash
Light Parameters.
2. Select a tab corresponded with the flash light control port.
The camera supports IO:1 and IO: 2.
IO:1 is the built-in flash light. IO:2 is the extra flash light.
Figure 11-1 Flash Light Parameters Configuration
3. Select IO Output Mode. Constant Light Mode is available.
 Constant Light Mode
1) Input Duty Ratio. It controls the power level of the flash light. 0 means
light off, 70 means full-power.
2) Set light on/off control mode. The on/off status can be controlled
automatically or on schedule.
Auto: Check Control Constant Light By Brightness. Set the brightness
threshold.
Schedule: Check Control Constant Light by Schedule. Set the start time