User's Manual

Network Video Recorder User Manual
180
OPTION 2: Manual
If you select Manual, you can edit the external port on your demand by clicking to
activate External Port Settings.

●
You can use the default port No., or change it according to actual requirements.
●
External Port indicates the port No. for port mapping in the router.
●
The value of the RTSP port No. should be 554 or between 1024 and 65535, while the value
of the other ports should be between 1 and 65535 and the value must be different from
each other. If multiple devices are configured for the UPnP™ settings under the same
router, the value of the port No. for each device should be unique.
Enter the virtual server setting page of router; fill in the blank of Internal Source Port with
the internal port value, the blank of External Source Port with the external port value, and
other required contents.

●
Each item should be corresponding with the device port, including server port, http port,
RTSP port and https port.
●
The virtual server setting interface below is for reference only, it may be different due to
different router manufactures. Please contact the manufacture of router if you have any
problems with setting virtual server.
Setting Virtual Server Item
Configure SNMP
Purpose
You can configure SNMP settings to get device status and parameter information.
Before You Start
Download the SNMP software to receive device information via SNMP port. By setting the trap
address and port, the device is allowed to send alarm event and exception message to the
surveillance center.
Go to System > Network > Advanced > SNMP.