User's Manual

Network Video Recorder User Manual
127
Go to the Linkage Action interface of the alarm input or event detection (e.g., motion
detection, facial detection, line crossing detection, intrusion detection, etc.).
Click the Trigger Alarm Output tab.
Select the alarm output (s) to trigger.
Go to System > Event > Normal Event > Alarm Output.
Select an alarm output item from the list.

Refer to Chapter 11.6.3 Configure Alarm Output for the alarm output settings.
Configure PTZ Linkage
The system can trigger the PTZ actions (e.g., call preset/patrol/pattern) when the alarm event, or
VCA detection events occur.

Make sure the PTZ or speed dome connected supports PTZ linkage.
Go to the Linkage Action interface of the alarm input or VCA detection (e.g., facial
detection, line crossing detection, intrusion detection, etc.).
Select the PTZ Linkage.
Select the camera to perform the PTZ actions.
Select the preset/patrol/pattern No. to call when the alarm events occur.
PTZ Linkage

You can set one PTZ type only for the linkage action each time.