User Manual

Table Of Contents
13.8 Restore Default Sengs
Steps
1. Go to Maintenance → Default .
Figure 13-15 Restore Default Sengs
2. Select the restore type from the following three opons.
Restore Defaults
Restore all parameters, except the network (including IP address, subnet mask, gateway,
MTU, NIC working mode, default route, server port, etc.) and user account parameters, to
the factory default
sengs.
Factory Defaults
Restore all parameters to the factory default sengs.
Restore to Inacve
Restore the recorder to inacve status.
Note
The recorder will reboot automacally aer restoring to the default sengs.
13.9 Security Management
13.9.1 RTSP Authencaon
You can specically secure the stream data of live view by seng the RTSP authencaon.
Steps
1. Go to System → System Service → System Service .
Figure 13-16 RTSP Authencaon
2. Select RTSP Authencaon Type.
Network Video Recorder User Manual
149