User Manual

ATM Digital Video Recorder User Manual
20
Troubleshooting Remote Control:
Make sure you have install batteries properly in the remote control. And you have to aim the
remote control at the IR receiver in the front panel.
If there is no response after you press any button on the remote, follow the procedure below to
troubleshoot.
Step 1 Go into Menu > Configuration > General > More Settings by operating the front control panel
or the mouse.
LEFT button is used to jump 30s backward; the RIGHT button is used
to jump 30s forward.
In PTZ control mode, the DIRECTION buttons are used to control the
movement of PTZ camera.
The ENTER button is used to confirm the selection in menu mode.
The ENTER button is used to check the checkbox or switch the
ON/OFF.
The ENTER button is used to play/pause the video in Playback mode
or advance the video by a single frame in single-frame Playback
mode.
The ENTER button is used to stop/start the auto switch in Auto-switch
mode.
13
PTZ Button
Enter the PTZ Control mode.
In the PTZ Control mode, it is used to adjust the iris of the PTZ
camera.
14
ESC Button
Back to the previous menu.
Enter the PTZ control interface in live view mode.
15
RESERVED
Reserved for future usage.
16
F1 Button
Select all items on the list when used in a list field.
In PTZ Control mode, it will turn on/off PTZ light (if applicable).
In Playback mode, it is used to switch play and reverse play.
17
PTZ Control Buttons
Buttons to adjust the iris, focus and zoom of a PTZ camera.
18
F2 Button
Cycle through tab pages.
In synchronous playback mode, it is used to switch channels.