User Manual

ATM Digital Video Recorder User Manual
17
1.2 IR Remote Control Operations
The device may also be controlled with the included IR remote control. Direct the remote control
at the IR receiver on the front panel of DVR for the operations.
Batteries (2×AAA) must be installed before operation.
ENTER
The button is used to confirm selection in any of the menu modes.
It can also be used to tick checkbox fields.
In Playback mode, it can be used to play or pause the video.
In single-frame Playback mode, pressing the button will advance the video
by a single frame.
In Auto-switch mode, it can be used to stop /start auto switch.
2
MENU
Access the main menu interface.
Switch the channels in PTZ control.
Select/deselect the HDD in HDD management interface.
3
ESC
Exit from the current interface.
Enter the PTZ control interface in live view mode.
4
IR Receiver
Receiver for IR remote control.
5
POWER
(Power
indicator)
Turn on/off the device.
Power indicator stays red when the device is powered on but is not turned
on.
Power indicator turns pink when the device is being turned on.
Power indicator stays blue when the device has been turned on.
6
USB
Interface
Universal Serial Bus (USB) ports for additional devices such as USB mouse
and USB Hard Disk Drive (HDD).
7
Tx/Rx
Tx/Rx indictor blinks blue when network connection is functioning properly.
8
HDD
HDD indicator blinks red when data is being read from or written to HDD
normally and stays red when the HDD is abnormal.
9
LCD Screen
7-inch LCD touch screen to display local menu and live view.