User Manual

Network Video Recorder User Manual
71
Event Output
Select the output to show the event video.
Full Screen Monitoring Dwell Time
Set the time in seconds to show the alarm event screen. If alarms are triggered
simultaneously in several channels, their full-screen images will be switched at an interval of
10 seconds (default dwell time).
3. Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
4. Select the Full Screen Monitoring alarm linkage action.
5. Select the channel(s) in Trigger Channel for full screen monitoring.
5.4.2 Configure Audio Warning
The audio warning has the system to trigger an audible beep when an alarm is detected.
Steps
1. Go to System → View → General.
2. Enable the audio output and set the volume.
3. Go to Linkage Action interface of the alarm detection (e.g., motion detection, video tampering,
face detection, etc.).
4. Select the Audio Warning alarm linkage action.
5.4.3 Notify Surveillance Center
The device can send an exception or alarm signal to the remote alarm host when an event occurs.
The alarm host refers to the PC installed with client software (e.g., iVMS-4200, iVMS-5200).
Steps
1. Go to System → Network → Advanced → More Settings.
2. Set the alarm host IP and alarm host port.
3. Go to Linkage Action interface of the alarm detection (e.g., motion detection, video tampering,
face detection, etc.).
4. Select Notify Surveillance Center.
5.4.4 Configure Email Linkage
The system can send an email with alarm information to a user or users when an alarm is
detected.
Steps
1. Go to System → Network → Advanced → Email.
2. Set the email parameters.
3. Click Apply.