User Manual

Digital Video Recorder User Manual
93
4. Select Notify Surveillance Center.
6.4.4 Configure Email Linkage
The system can send an email with alarm information to a user or users when an alarm is
detected.
Steps
1. Go to System → Network → Advanced → Email.
2. Set the email parameters.
3. Click Apply.
4. Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
5. Select Send Email alarm linkage action.
6.4.5 Trigger Alarm Output
The alarm output can be triggered by the alarm input, motion detection, video tampering
detection, face detection, line crossing detection, and any all other events.
Steps
1. Go to Linkage Action of the alarm detection (e.g., motion detection, face detection, line
crossing detection, intrusion detection, etc.).
2. In Trigger Alarm Outputs, select the alarm output(s) to trigger.
3. Go to System → Event → Normal Event → Alarm Output.
4. Select an alarm output item from the list.
6.4.6 Configure PTZ Linkage
The system can trigger the PTZ actions (e.g., call preset/patrol/pattern) when the alarm event, or
VCA detection events occurs.
Before You Start
Make sure the connected PTZ or speed dome connected supports PTZ linkage.
Steps
1. Go to Linkage Action interface of the alarm input or VCA detection (e.g., face detection, line
crossing detection, intrusion detection, etc.).
2. Select the PTZ Linkage.
3. Select the camera to perform the PTZ actions.
4. Select the preset/patrol/pattern No. to call when the alarm events occur.
Note
You can set only one PTZ type for the linkage action each time.